NYC 9/11 Public Portal Document
Part III — Health & Safety Plan
133-135 Greenwich Street/21-23 Thames Street
Airtek Project 05-0701— Rev 1, August 11, 2005
as adding organic vapor cartridges based on their respiratory protection programs and chemicals
they may be using. The following practices will be conveyed to all employees and enforced by
the Contractor and the CSO respect to respiratory equipment for this project:
1. Subcontractors whose personnel ee44e wear respiratory protection on-this
je , shall have a written respiratory protection program that meets the requirements of the
OSHA Standard (29 CFR 1910.134) and has been developed by a Competent Person as
defined by OSHA.
2. Personnel who may need to wear respiratory protection shall be fit-testing, medically
qualified and trained, as required by the Standard, to use respiratory protection. The
Subcontractor shall identify personnel who may use respiratory protection and
documentation of fit-testing, medical qualification and training shall be provided for each
person who may need to wear respiratory protection on the job.
3. The Subcontractor shall review with the Contractor CSO the procedures for the handling,
storage and maintenance of respiratory protective equipment to be used on-site, including
the process for reporting and repairing or replacing defective equipment and the locations
where respiratory equipment will be stored.
4. Subcontractors will provide employees with adequate respiratory protection as required
by each task.
5. A respirator of lesser protection than is required for the task/activity may not be used.
6. Each employee will change his/her respirator filter at the end of each work shift. The
Subcontractor will provide an adequate supply of approved filters for daily replacement
for each employee's respirator.
7. Each Subcontractor will ensure the adequacy of respiratory protection for his employees
based upon the verified results of personal air sampling.
8.. If at any time air sampling data indicates airborne exposures exceeding one-half the
OSHA Permissible Exposure Limit, all affected employees' respiratory protection will be
upgraded.
2.6.1.1 Respirator Testing
Each individual who must wear a respirator will be required to be clean-shaven where the sealing
areas of the respirator face piece contacts the face. Each respirator user will be respirator fit-
tested in accordance with 29 CFR 1910.134 at least annually. Upon donning the respiratory
device or before entering any restricted work area, each respirator wearer will be required to
perform a manual negative and positive-pressure test. Subcontractor employees who fail the
negative/positive pressure test because they are not clean shaven will be required to leave site for
the day or to shave on-site immediately preceding entry into the work area.
2.6.1.2 Respirator Inspection, Sanitization, and Maintenance
23
NYC-WTC 000135011
OCR can misread numbers and units. Confirm readings against the page image before using them.