Asbestos project monitor and air sampling contract, June 2002

NYC 9/11 Public Portal Document

JUN-11-2002 14:30 U.S. EPA REGION 2 REPP 906 906 6182 P.03/07 ,*

2. Air monitoring technicians must be on-site during clean-up activities to collect final clearance •samples. 3. The Project Monitor shall ensure that the clean up activities comply with the NYCDEP Scope of Work.

Post Clean-up Air Sampling Procedure must be as followed:

a) Sampling shall not begin until a visual inspection confirms the absence of visible debris.

b) All surfaces must be completely dry prior to the start of sampling.

c) Sampling equipment shall be placed at representative locations within the work area and away from obstructions. The sampling cassette must be placed on a tripod and not taped to existing surfaces.

d) Air conditioning units where applicable shall be run/operated at least 15 minutes prior to the start of sampling. The air conditioning units shall operate continuously .throughout the sampling. HVAC systems shall be in operation during sampling.

e) Forced air equipment (e.g, leaf blowers) may be used only after wriiien authorization by the occupant or his/her authorized representative. The project manager shall advise the occupant or his/her authorized representative on the advantages and disadvantages regarding the use of the equipment and obtain the individual's signature authorizing use. Before the start of sampling, forced air equipment (such as a 1 horsepower leaf blower) may be used to direct exhaust air against walls, ceilings, floor, ledges and other surfaces. When directing the exhaust, caution shall be taken to minimize disturbance and potential damage to furnishings and personal belongings.

f) One 20-inch fan shall be installed per 10,000 cubic feet of room space and run at low speed. The fan shall operate continuously throughout sampling and shall not be turned off until sampling is completed.

g) For studio apartments 3 s^ples shall be collected. For 1-bedroom apartments and above 5 samples shall be collected. Technicians shall collect a volume of 3000 liters per sample using a flow rate of 10 liters per minute.

h) Samples must be labeled and accompanied with completed chain of custody forms before shipping to the designated laboratory.

i) Project Monitor shall perform all final visual inspections.

j) All information must be maintained on a data based software program that is acceptable to the USEPA.

1. Project reports, including a project completion sign-off signed by the project monitor and the occupant or his/her authorized representative, must be typed and forwarded to USEPA with a copy to NYCDEP.

NYC-WTC_000151296