Asbestos abatement technical specifications, 130 Cedar Street, July 2004

NYC 9/11 Public Portal Document

Asbestos Abatement Technical Specifications For 130 Cedar Street, New York, NY

4.0 Special Conditions 0 4.1 The Contractor shall provide labor, materials and equipment to complete the work as by the Contract Documents, including but not limited to the following:

a. The filing of all required notifications and variances, including the payment of all fees charged by all regulatory agencies. b. Work area preparation. c. General protection. d. Isolation barrier construction. e. Removal of all ACM, asbestos contaminated building components and decontamination of all surfaces. f. Installation of personnel and waste decontamination facilities. g. Transportation and disposal of asbestos waste. i. Re-establishment of all building systems disrupted by the work of this contract. j. Repair or replacement, to the Owner's satisfaction, of any existing finishes, construction or other building components damaged during the work. k. Conduct daily inspections of all adjacent spaces and clean up as required.

4.2 If the Contractor has any questions as to possible errors or omissions In the Specifications, he shall immediately bring the discrepancy or other question to JLC's attention in writing and obtain a written decision as to the methods and materials to be used, before the submission of his bid. Failure to obtain clarification in writing shall not relieve the Contractor of performing the normal good practice of the industry.

4.3 All waste generated by the Contractor shall be disposed of as contaminated waste to a licensed landfill.

4.4 The Contractor shall provide all required plumbing and electrical work, including temporary connections. The Abatement Contractor shall provide a-- - -- - temporary electric panel for his equipment and, where required, shall provide temporary lighting in accordance with all applicable codes and standards.

4.5 Bidders are required to visit the premises prior to the time of submitting proposals for the work described herein, and thoroughly inspect the conditions under which the contract Is to be executed. The Contractor is responsible for field verification of all locations and quantities and determining all varying field conditions prior to the submission of their bid. Bids should include the removal of all ACM identified in the specifications and asbestos abatement drawings. Quantities provided herein are estimates and are meant to include all ACM.

4.6 The Building Owner shall provide water and electric power at each floor and at the roof. All temporary water connections shall be turned off and all water • hoses disconnected at the end of the work shift. All wastewater from the abatement activities shall be pre-filtered, stored in barrels and re-used as amended water or disposed of as contaminated waste.

Prepared by JLC Environmental Consultants, Inc. Project No. 04-3271 Page 6

NYC-WTC 000125584