Asbestos abatement technical specifications, 130 Cedar Street, July 2004

NYC 9/11 Public Portal Document

Asbestos Abatement Technical Specifications For 130 Cedar Street, New York, NY information to the examining physician regarding unusual conditions in the • work place environment (e.g., high terr~peratures, humidity and chemical contaminants) that may impact on the employees' ability to perform work activities.

1.7 A copy of the Contractor's and all Sub-Contractors' insurance certificates.

1.8 Manufacturer's certification that HEPA vacuums, required HEPA equipped ventilation units and other local exhaust ventilation equipment conform to ANSI Z9.2-79.

1.9 When rental equipment is to be used in abatement area or to transport asbestos contaminated waste, a written notification concerning intended use of the rental equipment must be provided to the rental agency with a copy submitted to the Owner(s)

1.10 MSI-IA/NIOSH approval documents for Iall respiratory protective devices utilized on site, including manufacturer certification of HEPA filtration capabilities for all cartridges and filters

1.11 Respiratory system information, including manufacturer's literature describing the air supply system and illustrating that it meets the specifications on supplying Grade "D" breathing air.

1.12 Copies of the Contractor's training program, safety manuals and policies, and his written respiratory protection program.

1.13 Standard operating procedure showing how workmen, visitors and Owner's employees will be protected from exposure, how space outside the work areas will be protected from contamination through completion of work, work procedures utilized during the project and final clean-up/decontamination procedures to be implemented.

1.14 The system, warning signs and labels for bags and drums.

1.15 Fire and emergency evacuation plan.

1.16 Plan for communication system between work area and outside (if necessary).

1.17 . Engineering systems for exposure control showing the number, location and capacity of air supply and exhaust systei`ns, the expected direction of flow and the maximum and minimum negative pressure allowed for each work area.

1.18 A list of equipment planned for use during this project, including manufacturer's literature and certifications if appropriate.

1.19 The Identification of encapsulant and material safety data sheets (MSDS).

is 1.20 The telephone location with ready access.

Prepared by JLC Environmental Consultants, Inc. Project No. 04-3271 Page 24

NYC-WTC 000125602