NYC 9/11 Public Portal Document
Regulatory Submittal Part IV- Waste Sampling & Management Plan
Fiterman Hall 30 West Broadway, New York, New York
Airtek Project 05-0867 — January 10, 2006
containers) and transferred to the waste storage area pending transport.
While being accumulated on-site, each container shall be labeled or
marked clearly with the words, "Hazardous Waste". Containers will be
inspected at least weekly to identify any leaks, and/or deterioration caused
by erosion or other factors, and to ensure containers are not over-packed.
Hazardous waste will not be placed in an unwashed container that
previously held an incompatible waste. Any disposal container holding a
hazardous waste that is incompatible with any waste or other materials
contained nearby will be separated from the other materials or protected
from them by means of a dike, berm, wall, or other device.
6.4 Universal Waste
After having been cleaned of dust with HEPA-vacuuming and wet-wiping
procedures, universal waste will be handled, packaged, and stored pending
transport according to all regulations governing universal wastes. The
requirements for handling, packaging and storage of hazardous waste
apply, and are discussed in Section 6.3.
6.5 PCB Waste
Non-leaking PCB waste (PCB bulk product waste, including fluorescent
light ballasts) will be packaged in suitable containers, properly labeled and
stored for transport in the Waste Storage Area. Any leaking PCB articles
or containers will be transferred to properly marked, non-leaking
containers or an over-pack container, and likewise labeled and stored for
transport.
6.6 Miscellaneous Contents
6.6.1 Containerized Chemicals/Products
Initial characterization has been conducted by review of existing labels
and/or Material Safety Data Sheets (MSDSs), as noted in the Chemical
Log in Attachment A. Specific requirements beyond initial
characterization are found in the applicable federal, state and city solid and
hazardous waste and DOT regulations. The Remediation Contractor will
be required to identify and apply the specific regulatory programs
applicable to specific waste types, and where appropriate, "Lab-Pack"
them.
6.6.2 Fuels
All noted fuels are to be removed as a part of the ongoing characterization
of the site under a re-opening of NYS DOL Variance 05-0919. If during
remediation and demolition further fuel products are identified, the
14
NYC-WTC 000095847
OCR can misread numbers and units. Confirm readings against the page image before using them.