NYC 9/11 Public Portal Document
Regulatory Submittal Part IV- Waste Sampling & Management Plan
Fiterman Hall 30 West Broadway, New York, New York
Airtek Project 05-0867 —January 10, 2006
asbestos-contaminated, will be used as the basis for the Waste Profile for the
particular waste stream.
6.0 Waste Packaging and Storage
Locked waste storage areas will be established in the southeast corner of the first
floor of the Building to accommodate both categorized waste awaiting transport,
and suspect waste awaiting analyses (See Attachment C). Storage areas will be
plasticized, and any liquid storage will have secondary containment. Incompatible
waste streams will be segregated, and waste labeling and signage will be in strict
accordance with regulations. Within the storage area, posted signs, labeled
accumulation start dates, labeled description of the waste, aisle space, proper
segregation of incompatible and or/ignitable waste, etc. will be inspected on a
daily basis by the Environmental Consultant. Statutory waste volume and holding
times shall not be exceeded.
All containers on site will have proper labeling, which includes information such
as waste type and accumulation date.
6.1 Asbestos Waste
Waste containing asbestos, containerized and labeled per NYS ICR 56
may be stored in an area maintained tinder a negative pressure ventilation
system. ACM packaging and waste decontamination procedures will be in
accordance with NYS Industrial Code Rule 56. Containers holding
asbestos waste will be inspected daily to ensure no visible emissions of
asbestos dust in the air or breaks in the container.
Storage of asbestos waste will not exceed 50 cubic yards. Authorization
from the New York City Department of Sanitation (NYCDOS) and
additional requirements, per code, will be required if accumulation of
asbestos is anticipated to be greater than 50 cubic yards.
6.2 PPE and Remediation Process Consumables
PPE and Remediation Process Consumables will be packaged, labeled and
stored as ACM waste as a minimum, and based on the results of the dust
characterization study. In addition, packaging and storage of these wastes
will be subject to the results of representative sampling conducted
according to Section 4.2.
6.3 Hazardous Waste
Hazardous waste will be placed in containers made of or lined with
materials that will not react with, and are otherwise compatible with, the
hazardous waste to be stored so that the ability of the container to contain
the waste is not impaired (e.g., USDOT approved drums, bags, roll-off
13
NYC-WTC 000095846
OCR can misread numbers and units. Confirm readings against the page image before using them.