7 World Trade Center Blue Prints Haz Mat Info Fire Reports Fire Prevention Records

NYC 9/11 Public Portal Document

\iSIJS loi M29 D.T.M. Acrylic Scmi-Gloss hup://www.hcni:iiiiin moorc.coin/msds/MSDS/M29.htii

INCOMPATIBILITY (MATERIALS TO AVOID): None reasonably foreseeable.

SECTION VII - SPILL OR LEAK PROCEDURES

STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED: Flush with water. Absorb with sawdust or rags.

WASTE DISPOSAL METHOD: Conventional procedures in compliance with local, state and federal regulations. Do not incinerate sealed containers.

SECTION VIII - SAFE HANDLING AND USE INFORMATION

RESPIRATORY PROTECTION: Wear a properly fitted vapor/particulate approved by NIOSH/MSHA for use with paints (TC-23C) during application or sanding and until all vapors and spray mist are exhausted. In confined spaces or in situations where continuous spray operations are typical, or if proper respirator fit is not possible, wear a positive-pressure, supplied air respirator (NIOSH/MSHA TC-19C)

VENTILATION: Adequate to maintain working atmosphere below T.L.V. and L.E.L. (See Sect. II for ingredient data and concentrations). Mechanical exhaust may be required in confined areas.

PROTECTIVE GLOVES: Solvent impermeable gloves are required

EYE PROTECTION: Splash goggles or safety glasses with side shields.

OTHER PROTECTIVE EQUIPMENT: Clothing adequate to protect skin.

HYGIENIC PRACTICES: Remove and wash clothing before reuse. Wash hands before eating, smoking or using the washroom.

SECTION IX - SPECIAL PRECAUTIONS

PRECAUTIONS TO BE TAKEN IN HANDLING AND STORAGE: Do not throw or drop containers.

OTHER PRECAUTIONS: Avoid contact with eyes and prolonged contact with skin or breathing of spray mist or sanding dust. Close container after each use. Keep out of reach of children. Do not take internally.

SECTION XX

HMIS (Hazardous Materials Identification System) (R) NPCA

HMIS is a recognized workplace Hazard Communications System as required by OSHA (29 CFR 1910. 1200). Information on establishing a compliant hazardous communication program using HMIS is available from:

American Labelmark Co., Inc., Labelmaster Division 5724 N. Pulaski Rd., Chicago, IL 60646 1-800-621-5808

The ratings assigned by Benjamin Moore & Co. are only suggested ratings; the contractor/ employer has ultimate responsibility for HMIS rating where this system is used.

PERSONAL PROTECTION: This code is left blank on Benjamin Moore & Co. MSDS's as it depends on application technique and the workplace ventilation. Please read Sections II through IX of this MSDS before deciding on appropriate protective equipment and beginning work. There are codes available for this

of 4 1/29/01 8:56 AM NYC-WTC_000169046