NYC-WTC_000199352

NYC 9/11 Public Portal Document

Scope of Work

ATC Associates, Inc. (ATC) was retained by New York City Board of Education (NYC- BOE) to collect dust wipes to be analyzed for lead content. Du it wipe samples were collected from areas recommended by the NYC- BOE. These areas are the following:

• Main Lobby • Cafeteria • r* Floor, 2"" Floor, 3"* Floor, 4*^ Floor, 5‘" Floor Hallways • 1 ’* Floor Play Area • 2“* Floor Auditorium • Room 213, 402

The purpose of the dust wipe sampling is to determine if dust in the school contains lead. ATC’s representative Mr. Herant Antonyan visited P.S. 001 M located at 8 Henry Street, New York, NY on August 24, 2002. Dust wipes to be analyzed for lead content were collected from the aforementioned areas indicated by the New York City Board of Education Environmental Health & Safety Unit and in accordance v ith HUD protocols. i LEAD-IN-DUST SAMPLING

Lead-in-dust threshold levels The New York City Health Code, part 173.14 and the Federal Departments of Housing and Urban Development (HUD) and Environmental Protection Agency f3PA) have established acceptable lead-in-dust levels for re-occupancy after a lead abatement has occurred (commonly referred to as “final clearance” levels). As stated in the Code, final clearance after abatement has taken place is achieved when dust wipe samples indicate lead levels below those listed below:

For Windowsills: 250 pg/ff For Floors: 40 pg/tf

Although the lead-in-dust samples collected at P.S. 001 M were not collected in response to lead abatement, the same thresholds are used since no other regulations or standards are applicable to this project.

Sampling Methodology ATC provided all laboratory analytical services in support of this lirr ited inspection. ATC is certified by the New York State Department of Health’s Envi -onmental Laboratory Accreditation Program to perform lead and related analyses of environmental samples (Laboratory ID Number: 10879). The laboratory utilizes the United States Environmental Protection Agency analysis method number SW846-7420 and the National Institute of Occupational Safety and Health method number 7082M.

P.S. 00IM <Swrc *ctcci«itt me. August 27, 2002

CITY_21MC100_003033475

NYC-WTC_000199353