E-Z Denatured Solvent Alcohol MSDS, Jan 1997

NYC 9/11 Public Portal Document

sources at locations distant from material handling point. Never use welding or cutting torch on or near _ drum (even empty) because product (even just residue) can ignite explosively. EXTINGUISHING MEDIA; Alcohol foam, carbon dioxide, dry chemical. HRE nCHTING INSTRUCTIONS; Wear a self-contained breathing apparatus with a full facepiece operated in the positive pressure demand mode with appropriate turn-out gear and chemical resistant personal protective equipment. Refer to the personal protective equipment section of this MSDS. NFPA Rating; Not determined

Section 6. ACaDENTAL RELEASE MEASURES

SMALL SHLk Absorb liquid on vermiculite, floor absorbent or other absorbent material. LARGE SHLk Eliminate all ignition sources (flares, flames including pilot lights, electrical sparks). Persons not wearing protective equipment should be excluded from area of spill until ciean-up has been completed. Stop spill at source. Prevent from entering drains, sewers, streams or other bodies of water. Prevent from spreading. If runoff occurs, notify authorities as required. Pump or vacuum transfer spilled product to clean containers for recovery; Absorb unrecoverable product Transfer contaminated absorbent, soil and other materials to containers for disposal. Prevent runoff to sewers, streams or other bodies of water. If runoff occurs, notify proper authorities as required, that a spill has occurred.

Section 7. HANDLING AND STORAGE

HANDUNG: Containers of this material may be hazardous when emptied. Since emptied containers retain product residues (vapor, liquid, and/or solid), all hazard precautions given in the data sheet must be observed. All five gallon pails and laiger metal containers including tank cars and tank trucks should be grounded and/or bonded when material is transferred. WARNING. Sudden release of hot organic chemical vapors or mists from process equipment operating at elevated temperature and pressure, or sudden ingress of air into vacuum equipment, may result in ignitions without the presence of obvious ignition sources. Published "autoignition" or "ignition* temperature values cannot be treated as safe operating temperatures in chemical processes without analysis of the actual process conditions. Any use of this product in elevated temperature processes should be thoroughly evaluated to establish and maintain safe operating conditions.

Sections. EXPOSURECONTROLS/PERSONALPROTECTION

EYE PROTECTION: Chemical splash goggles in compliance with OSHA regulations are advised; however, OSHA regulations also permit other type safety glasses. Consult your safety representative. SKIN PROTECTION: Wear resistant gloves (consult your safety equipment supplier). To prevent repeated or prolonged skin contact, wear impervious clothing and boots. respiratory PROTECTIONS; If workplace exposure Iimit(s) of product or any component is exceeded (see exposure guidelines), a NIOSH/MSHA approved air supplied respirator is advised in absence of proper environmental control. OSHA regulations also permit other NIOSH/MSHA respirators (negative pressure type) under specified conditions (see your industrial hygienist). Engineering or administrative controls should be implemented to reduce exposure. ENGINEERING CONTROLS; Provide sufficient mechanical (general and/or local exhaust) ventilation to maintain exposure below TLV(s).

Page 3 of 6

NYC-WTC_000169074