NYC 9/11 Public Portal Document
Part III — Health & Safety Plan
133-135 Greenwich Street/21-23 Thames Street
Airtek Project 05-0701— Rev 3, August 29, 2005
4. Subcontractors will provide employees with adequate respiratory protection as required
by each task.
5. A respirator of lesser protection factor than is required for the task/activity may not be
used.
6. Each employee will change his/her respirator filter at the end of each work shift. The
Subcontractor will provide an adequate supply of approved filters in accordance with the
manufacturers specifications for daily replacement for each employee's respirator.
7. Each ubcontracto will ensure the adequacy of respiratory protection for his employees
based u nfied results of personal air sampling.
8. If at any time air sampling data indicates airborne exposures exceeding one-half the
OSHA Permissible Exposure Limit, all affected employees' respiratory protection will be
upgraded.
9. Personal air sampling results shall be posted on the Decontamination unit during the
abatement phase, and the site management station during the deconstruction phase.
2.6.1.1 Respirator Testing
Each individual who must wear a respirator will be required to be clean-shaven where the sealing
areas of the respirator face piece contacts the face. Each respirator user will be respirator fit-
tested in accordance with 29 CFR 1910.134 at least annually. Upon donning the respiratory
device or before entering any restricted work area, each respirator wearer will be required to
perform a manual negative and positive-pressure test. Subcontractor employees who fail the
negative/positive pressure test because they are not clean shaven will be required to leave site for
the day or to shave on-site immediately preceding entry into the work area.
2.6.1.2 Respirator Inspection, Sanitization, and Maintenance
All respirators will be cleaned, sanitized, inspected, assembled, and maintained ready for use on
a daily basis. Each respirator will be stored in a clean and sanitary container. Prior to use, the
wearer will inspect the respirator, including the valves, valve covers, nosepiece, straps, eyepiece
(for full-face respirators), face piece and its snaps, cylinders, and canisters to insure that the
respirator can be worn. The Subcontractor will provide initial training concerning the use of
respirator equipment, but each employee will be responsible for cleaning, inspecting,
maintaining, sanitizing, and storage of his/her respirator equipment.
If a respirator becomes chemically contaminated or malfunctions, the respirator will be replaced
by the employer with a clean and sanitized respirator, and the contaminated/defective respirator
shall be decontaminated and repaired before reuse, or tagged "out of service" and disposed of.
The respirator wearer shall inspect the replacement respirator for defective parts and leaks and
will be fit tested if the replacement respirator is of a different make, model or size than the
original.
25
NYC-WTC 000134292
OCR can misread numbers and units. Confirm readings against the page image before using them.