NYC 9/11 Public Portal Document
Nov-lO-£»0 O3i,13P VIKONICS ■201 641 7728 P . 11
MAYOR’S O!'I ICI- 01' EMGROI’MCY MANAORMI^C’ coNuuir sicuRi n’ sYsn:M si’hciHCAnoN
't R'-'
3.1 Electronic Security Wiring Requirements
All wiring is to conform to applicable building codes. All wires arc to be
pemiancntly marked with ths wire numbers showm on the wire lists.
3 J Sensor Mounting and Wiring Requirements
End of line resi.stor.s arc to be in.stal!cd on each ,sen.sor proces.sor. The 1'0’- resistor
network is to be wired as shown in Figure 3-1.
FIGURE 3-1. END OF LINE RESISTOR WIRING
TYPICAL
SUPERVISED
SENSOR WITH
EOL NETWORK
Tamper
Switch •
2200
4700
JY
Alarm
Contact' ^TO PANEL ZONE
TYPICAL SENSOR WIRING * Normally Closed
Continuity is to be tested on all wiring. Vikonics will program the sensor processors.
TABLE 3-2. ALARM WIRING REQUIREMENTS
FROM LOCATION Wire Req. wire # To Panel Panel Location
FD-205M ROOF CONDUIT 2 PR 18 AWC SHIELDED 351 AMP 10-5 RM 23-50
FD-2051/2 7*' Fl WR CONDUIT 2 PR 18 AWG SlllitLDED 352 AMP 10-6 RM 23-50
VIKONICS, INC iloaK’-a KIA I! NoseniherM, pws
NYC-WTC_000171952
OCR can misread numbers and units. Confirm readings against the page image before using them.