NYC 9/11 Public Portal Document
Asbestos Abatement Technical Specifications
For 130 Cedar Street, New York, NY
f. Disposal shall be at an approved landfill, transfer at a licensed transfer
• station and a manifest form will be signed by the landfill owner
documenting receipt and acceptance of the ACW.
SECTION NINE: AIR MONITORING, TESTING, AND INSPECTIONS
1.0 Inspection and Testing
1.1 Air sample collection, final clearance Inspections and monitoring of the
Contractor's work practices shall be conducted by a certified New York State
Project Monitor.
1.2 Air sample analysis shall be conducted by individuals possessing the following
professional qualifications:
a. Proficiency (P) Rating In the. NIOSH Proficiency In Analytical
Testing Program (PAT).
b. Accreditation by the State of New York Environmental Laboratory
Approval Program (ELAP).
c. The analysis staff shall be independent of all parties involved in the
asbestos project.
2.0 Personal (OSHA) Monitoring
2.1 At the end of the project the Contractor shall provide complete documentation
of the OSHA required monitoring of on-site personnel that was conducted
during the abatement activities. This information will document the worker
exposure on this particular project.
3.0 Monitoring Requirements
3.1 Prior to the commencement of large project abatement activities the work
area shall be pre-tested to determine ambient airborne asbestos levels. A
minimum of five (5) inside the work area and five (5) outside the work area
samples shall be collected throughout the proposed work area during normal
occupancy activities and circumstances.
3.2 The following conditions shall determine the minimum number of air samples
to be collected on a daily basis at the large project work site:
a) Four (4) samples within ten (10) feet of isolation barriers.
b) One (1) sample at the exhaust of each air filtration device (microtrap)
exhausting Indoors on the project.
Prepared by JLC Environmental Consultants, Inc. Project No. 04-3271 Page 59
NYC-WTC 000125637
OCR can misread numbers and units. Confirm readings against the page image before using them.