E-mails 2003 M. Gilsenan

NYC 9/11 Public Portal Document

Cleaning Procedures Hiif 2(W For 114 Liberty Street

immediately brought to the attention of DEP. DEP will provide a determination. Any agreement to dispose the item(s) must be received in writing from the owner and/or resident as applicable.

(17) Resident and/or owner, as applicable, must identify items to be cleaned or disposed. Tags shall be placed on items to be disposed. The contractor shall dispose tagged items unless otherwise indicated in this scope of work. Special conditions or handling instructions may also be specified within units. These include items/locations not to be incorporated in this scope of work. Residents shall provide written notice of special instructions and items not to be handled with their authorizations.

a) Residents and/or owner shall identify items for disposal with clearly legible tags. Residents and/or owner, as applicable, shall make the final decision on cleaning or disposal of items. Items shall be cleaned by wet wiping and/or HEPA-vacuuming procedures, as appropriate. Compressed dry air (low pressure) may be used to blow debris/dust from openings/crevices in the items. HEPA vacuuming must be preformed in conjunction with this procedure. Care must be taken not to damage the items. Residents shall provide a written listing of items.

b) [terns identified for disposal (tagged) shall be double-wrapped in 6-mil polyethylene sheeting and labeled as ACM waste or bagged in labeled ACM waste bags. The cleaning of items to be disposed is not required. In lieu of disposal as ACM waste, larger items may be cleaned and disposed as non-regulated waste with prior approval by the Department.

c) Built-in items shall be disassembled, removed, and stored in a central location prior to the initiation of this contract by the resident/owner. The components of the built-in cabinets shall be wet wiped, HEPA vacuumed, and stored within each unit in a designated staging area for these items. The contractor shall not be responsible for removing or disassembling other built-in items that may be present. Built-in items shall be cleaned in place using wet wiping and HEPA vacuuming techniques.

d) Kitchen stoves, refrigerators, dishwashers, etc. shall be wet wiped and HEPA vacuumed, and shall remain in the units. The surfaces beneath the appliances shall be cleaned in causing damage to cabinets or appliances.

(18) All equipment used for cleaning activities shall be vacuumed and/or wet wiped prior to removal from the work area.

(19) The project monitor shall perform a thorough visual inspection to verify the absence of visual dust accumulations. Additional clean-up procedures shall be performed where visible dust is observed.

(20) Upon successful visual inspection, the work area shall be isolated from the remainder of the work site pending clearance monitoring. Clearance monitoring shall be performed after completion of all clean up activities at the work site.

(21) The Technician(s) shall perform clearance sampling after the area is free of dust accumulations as determined by the Project Monitor. The apartment will be re-cleaned and retested if the clearance criteria are not achieved. The Contractor is responsible for the costs of re-cleaning associated with

3 of 4

NYC-WTC_000162835