NYC 9/11 Public Portal Document
2.0 Executive Summary
ALC Environmental Incorporated (ALC) has been retained to perform bulk sampling, visual assessments
& air monitoring according to the EPA Protocol to determine the presence of asbestos at the above
referenced project. Every apartment in the building was assessed by our inspectors for dust and debris.
Any area where visible dust and debris was found, ALC's inspectors took a sample, which was then sent to
a third party independent laboratory for analysis. In most cases there was insufficient debris to sample and
a visual assessment only was performed. All samples analyzed were found to be below the permissible
limits for asbestos.
ALC then collected TEM samples on every floor in the building. The air sampling and analysis was done
utilizing applicable Federal, State and City Regulations pertaining to asbestos to include Federal OSHA (29
CFR 1926.58) EPA NESHAPS (40 CFR PART 61), AND TSCA TITLE II AHERAIASHARA (40 CFR
PART 763) Asbestos Regulations; the New York State Department of Labor Industrial Code Rule 56 and
the New York City Department of Environmental Protection Title 15 Asbestos Regulations.
The air samples were collected by Americo Rodriguez Jr.,a licensed project monitor (AH# 89-07160). The
visual assessment and bulk samples were collected by, A.R. Blake a NY State Asbestos Inspector (AH#00-
0839 71 and Americo Rodriguez, a NY State Asbestos Inspector (AH#89-07160).
ATC Associates (ELAP #10879) analyzed the samples using the Transmission Electron Microscopy (TEM)
Methodology. The results indicated that the living areas achieved the acceptance criteria below <70
structures per mm2 set by the above regulations.
0
3.0 Definitions
Air Sampling: Process of measuring the fiber content of a known volume of air collected during a specific
period. The procedure utilized for asbestos follows the NIOSH Standard Analytical Method 7400, or the
provisional transmission electron microscopy methods developed by the US EPA which are utilized for
lower detection levels and specific fiber identification.
Asbestos: Any hydrated mineral silicate separable into commercially usable fibers, including but not
limited to chrysotile (serpentine), amosite (cumingtonite-grunerite), crocidolite (riebeckite), tremolite,
anthophyllite and actinolite.
Asbestos-Containing Material (ACM): Asbestos or any material containing more than one-percent
asbestos.
Clearance Air Monitoring: Employment of aggressive sampling techniques with a volume of air collected
to determine the airborne concentration of residual fibers and shall be performed as the final abatement
activity.
FLAP: Environmental Laboratory Approval Program administered by the New York State Department of
Health.
NYC-WTC 000120943
OCR can misread numbers and units. Confirm readings against the page image before using them.