NYC 9/11 Public Portal Document
Certificate of Analysis
CLIENT INFORMATION LABORATORY INFORMATION
Attention: Vaughan O'Neill Contact: Julius Fulop, M.Sc., C.Chem.
Client Name: Philip Analytical Services Inc Project: AN030286
Project: JLC Environmental Date Received: 06-Mar-2003
Project Desc: Date Reported: 19-Mar-2003
Address: 4418 Pottsville Pike Submission No.: 3C0148
Reading, Pennsylvania Sample No.: 009192-009222
19605
Fax Number: 610 921-9667
Phone Number: 610 921-8833
NOTES: "-' not analysed '<' = less than Method Detection Limit (MDL) 'NA' = no data available
LOQ can by determinedfor all analytes by multiplying the appropriate MDL X3.33
Blank correction is only performed on oil and grease, BTEX, total purgeable hydrocarbons
and VOC analyses when Canadian methods are utilized
Solids data is based on dry weight exceptfor biota analyses.
Organic analyses are not correctedfor extraction recovery standards exceptfor isotope
dilution methods, (I.e. CARE 429 PAH, all PCDD/F and DBD/DBF analyses)
The enclosed copy of the Chain of Custody Record may contain information necessaryfor the
interpretation of the data.
Methods used by PSC Analytical Services are based upon those found in 'Standard Methods for the Examination of
Water and Wastewater', Twentieth Edition. Other methods are based on the principles of MISA or EPA methodologies.
New York State: ELAP Identification Number 10756.
All work recorded herein has been done in accordance with normal professional standards using accepted testing
methodologies, quality assurance and quality control procedures except where otherwise agreed to by the client
and testing company in writing. Any and all use of these test results shall be limited to the actual cost of the
pertinent analysis done. There is no other warranty expressed or implied. Your samples will be retained at
PSC Analytical Services for a period of three weeks from receipt of data or as per contract.
COMMENTS:
Certified by: Page 1 of 1
NYC-WTC 000100954
OCR can misread numbers and units. Confirm readings against the page image before using them.